BOOM CYLINDER (CONT’D) Figure 20-20-24 Disassembly Use the following tools to disassemble the cylinder. MEL1074-O-Ring Seal Hook 1 Clamp the base end of the cylinder in a vise. Figure 20-20-22 2 2 P-36056 Remove the tubeline (Item 1) and blocks (Item 2) [Figure 20-20-24] . Figure 20-20-25 1 P-36053 1 Install a block (Item 1) [Figure 20-20-22] under the end of the cylinder housing. Use care not to damage the cylinder housing. Figure 20-20-23 1 P-36057 Remove the 4 bolts (Item 1) [Figure 20-20-25] and remove the boom load holding valve. 1 1 For boom load holding valve disassembly. (See Disassembly on Page 20-200-3.) P-36054 Remove the clamps (Item 1) [Figure 20-20-23] .
442 Excavator 20-20-8 Service Manual