TORQUE SPECIFICATIONS FOR BOLTS Torque For General SAE Bolts The following table shows standard torque specifications for bolts with zinc phosphate coating. Bolts purchased from Melroe that have zinc phosphate coating are specified by the letter H following the part number. Torque For General Metric Bolts 442 Excavator SPEC-50-1 Service Manual THREAD SIZE SAE GRADE 5 SAE GRADE 8 INCH LBS. (Nm) .250 80-90 (9,0-10,2) 110-120 (12,4-13,6) .3125 180-200 (20,3-22,6) 215-240 (24,2-27,1) FOOT LBS.
(Nm) .375 25-28 (34-38) 35-40 (47-54) .4375 40-45 (54-61) 60-65 (81-88) .500 65-70 (88-95) 90-100 (122-136) .5625 90-100 (122-136) 125-140 (170-190) .625 125-140 (170-190) 175-190 (240-260) .750 220-245 (300-330) 300-330 (410-450) .875 330-360 (450-490) 475-525 (645-710) 1.000 475-525 (645-710) 725-800 (985-1085) 1.125 650-720 (880-975) 1050-1175 (1425-1600) 1.250 900-1000 (1200-1360) 1475-1625 (2000-2200) 1.375 1200-1350 (1630-1830) 2000-2200 (2720-2980) 1.500 1500-1650 (2040-2240) 2600-2850 (3530-3870) 1.625 2000-2800 (2720-2980) 3450-3800 (4680-5150) 1.750 2500-2750 (3390-3730) 4300-4800 (5830-6500) 1.875 3150-3500 (4270-4750) 5500-6100 (5830-6500) 2.000 3800-4200 (5150-5700) 6500-7200 (8800-9800) Grade Standard Screw and Bolt 4 Special Screw and Bolt 7 Nominal Diameter Unit Nm kfg m ft lbs Nm kgf m ft lbs M6 7.9 to 9.3 0.80 to 0.95 5.8 to 6.9 9.8 to 11.3 1.00 to 1.15 7.23 to 8.32 M8 17.7 to 20.6 1.8 to 2.1 13.0 to 15.2 23.5 to 27.5 2.4 to 2.8 17.4 to 20.3 M10 39.2 to 45.1 4.0 to 4.6 28.9 to 33.3 48.1 to 55.9 4.9 to 5.7 35.4 to 41.2 M12 62.8 to 72.6 6.4 to 7.4 46.3 to 53.5 77.5 to 90.2 7.9 to 9.2 57.1 to 66.5