BOOM CYLINDER (CONT’D) Figure 20-20-51 Assembly (Cont’d) Figure 20-20-49 1 2 1 P-36071 Install the seal (Item 1) [Figure 20-20-51] on the piston. P-36078 Figure 20-20-52 Install the O-ring (Item 1) and back-up ring (Item 2) [Figure 20-20-49] on the head. Figure 20-20-50 P-36072 1 Install the back-up rings (Item 1) [Figure 20-20-52] . P-35979 Install the new seal on the tool and slowly stretch it until it fits the piston [Figure 20-20-50] . Allow the seal to stretch for thirty seconds before installing it on the piston. 442 Excavator 20-20-15 Service Manual