ARM CYLINDER (CONT’D) Figure 20-21-36 Assembly Use the following tools to assemble the cylinder: MEl1396-Universal Seal Expander MEL1033-Rod seal Installation Tool Piston Ring Compressor Wash the cylinder parts in clean solvent and dry them with compressed air. Inspect the cylinder parts for nicks, scratches or other damage. Replace any damaged parts. P-36085 Always install new O-rings and seals during assembly. Lubricate all O-rings and seals with hydraulic oil during installation. Figure 20-21-37 Figure 20-21-35 1 1 P-36086 P-36084 Make sure the bearing is fully seated in the housing [Figure 20-21-36] and install the snap ring (Item 1) [Figure 20-21-37] .
Install the bearing (Item 1) [Figure 20-21-35] in the rod end. NOTE: The bearing can only be installed from the snap ring side of the housing. 442 Excavator 20-21-11 Service Manual