ARM CYLINDER (CONT’D) Figure 20-21-53 Assembly (Cont’d) Figure 20-21-51 Fully seat the bearing and install the snap ring (Item 1) [Figure 20-21-53] . P-36083 Install a ring compressor on the piston (Item 1) [Figure 20-21-51] and compress the seal to the correct size. Figure 20-21-54 Leave the piston in the compressor for three minutes. Remove the rod and head assembly from the vise. 3 Figure 20-21-52 1 2 P-36155 Clamp the base end of the cylinder in a vise and support the end of the housing with a block (Item 1) [Figure 20- 21-54] . 1 Use care not to damage the cylinder housing. P-36066 Support the rod assembly with wood blocks (Item 2) [Figure 20-21-54] .
Install the bearing (Item 1) [Figure 20-21-52] into the base end of the cylinder housing. Install a ring compressor (Item 3) [Figure 20-21-54] on the piston to compress the steel rings to the correct size. NOTE: The bearing can only be installed through the snap ring side of the housing. Push the piston into the housing. 442 Excavator 20-21-15 Service Manual 1 P-36068 P-36068