BOOM OFFSET CYLINDER Figure 20-22-3 Testing Swing the boom to the right, fully extending the boom offset cylinder. 1 Lower the boom/bucket to the ground. Stop the engine. Figure 20-22-1 P-33701 Remove the pin (Item 1) [Figure 20-22-3] . 1 Figure 20-22-4 P-33699 Remove the bolt (Item 1) [Figure 20-22-1] . Installation: Tighten the bolt to 48-55 ft.-lb. (65-75 N•m) torque. Figure 20-22-2 1 P-33702 Place a board (Item 1) [Figure 20-22-4] between the cylinder and excavator frame. 1 P-33700 Remove the spacer (Item 1) [Figure 20-22-2] . 20-22-1 442 Excavator Service Manual