Bobcat Company 442 — Disassembly

BOOM OFFSET CYLINDER (CONT’D) Figure 20-22-26 Disassembly Use the following tools to disassemble the cylinder: 1 MEL1074-O-ring Seal Hook Hold the hydraulic cylinder over a drain pan and move the rod in and out slowly to remove the fluid from the cylinder. Clamp the base end of the cylinder in a vise. Figure 20-22-24 P-36065 Remove the rod assembly (Item 1) [Figure 20-22-26] . Remove the cylinder housing from the vise. Figure 20-22-27 1 P-36182 Support the cylinder with a block (Item 1) [Figure 20-22- 24] . Use care not to damage the cylinder housing. 1 Figure 20-22-25 1 P-36068 Remove the snap ring (Item 1) [Figure 20-22-27] from the base end of the cylinder.

P-36064 Remove the 12 bolts (Item 1) [Figure 20-22-25] . 20-22-9 442 Excavator Service Manual