Bobcat Company 442 — Removal And Installation

BUCKET CYLINDER Removal And Installation Testing Fully retract the bucket cylinder. Fully retract the bucket and arm cylinders. Fully retract the arm cylinder and lower the boom until the bucket is on the ground. Lower the boom to the ground. Figure 20-23-65 With the engine off and the key in the run position, move the joysticks to relieve hydraulic pressure. Figure 20-23-63 1 1 P-33713 Support the arm with a chain hoist (Item 1) [Figure 20- 23-65] . P-33714 Remove the hydraulic hose (Item 1) [Figure 20-23-63] from the base end of the bucket cylinder. With the engine off and the key in the run position, move the joysticks to relieve hydraulic pressure.

Figure 20-23-64 IMPORTANT 2 1 When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. I-2003-0888 P-36030 Install a plug (Item 1) [Figure 20-23-64] on the hose. Start the engine and retract the bucket cylinder. If there is any oil leakage from the base end fitting (Item 2) [Figure 20-23-64] on the bucket cylinder, remove the cylinder for repair or replacement. 442 Excavator 20-23-1 Service Manual