Bobcat Company 442 — Disassembly

BLADE CYLINDER (CONT’D) Figure 20-24-13 Disassembly IMPORTANT When making repairs on hydraulic system, clean the work area before disassemble and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. 1 2 I-2056-0793 P-35994 Use the following tools to disassemble the cylinder. MEL1074-O-Ring Seal Hook Remove the bolt (Item 1) and seal carrier (Item 2) [Figure 20-24-13] from the fittings. Hold the cylinder over a drain pan and slowly move the rod in and out to remove the oil from the cylinder. Figure 20-24-14 NOTE:

The blade cylinder on the right side of the excavator has a check valve installed in the base end port which will prevent the hydraulic oil from being drained from the base end of the cylinder. 1 Figure 20-24-12 2 P-35996 Remove the O-ring (Item 1) [Figure 20-24-14] from the bolt. 1 P-35993 Clamp the base end of the cylinder housing in a vise [Figure 20-24-12]. Be careful not to damage the cylinder housing. Install a block (Item 1) [Figure 20-24-12] to support the cylinder. Remove the fittings (Item 2) [Figure 20-24-12] . 442 Excavator 20-24-5 Service Manual