BLADE CYLINDER (CONT’D) Figure 20-24-25 Disassembly (Cont’d) Figure 20-24-23 2 1 3 1 2 P-35974 Remove the wear rings (Item 1) and seal (Item 2) [Figure 20-24-25] from the head. P-35984 Clamp the rod end in a vise and install a wood block to support the end of the rod [Figure 20-24-23] . Use care not to damage the rod. Figure 20-24-26 1 Apply moderate heat to the nut (Item 1) [Figure 20-24- 23] and loosen the nut. Remove the nut (Item 1), piston (Item 2) and head (Item 3) [Figure 20-24-23] 3 2 Figure 20-24-24 3 P-35977 1 Remove the wiper (Item 1), seal (Item 2) and wear ring (Item 3) [Figure 20-24-26] .
1 2 P-35982 Remove the wear rings (Item 1), back-up rings (Item 2) and seal (Item 3) [Figure 20-24-24] from the piston. 442 Excavator 20-24-8 Service Manual