Bobcat Company 442 — Hydraulic Pump Work Sheet

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) Hydraulic Pump Work Sheet (Please review pump procedure as illustrated in “Pump Testing” on page 6 ) If any of the following adjustments are not obtainable, pump repair is required. The outline listed below, gives the four adjustments for setting the hydraulic pump. The adjustments are listed in the order in which they MUST be performed. Below each adjustment is a list of the steps. Behind each adjustment is the page location within the Service Manual for the complete adjustment procedure. I. “Torque Limiter Supply Pressure Adjustment” on page 6 4. Bottom Out Pump Margin Spool (Approximately 6 Turns In.) 5.

Remove the plug and install fitting and hose from the Torque Limit Supply Spool to a drain pan. 6. Install a 725 PSI (50 bar) pressure gauge on the test port on the six spool control valve. 7. Warm hydraulic fluid to 122 ° - 144 ° F (50 ° - 60 ° C). 8. Run Engine at High Idle 9. Adjust as Necessary to get 290 ± 20 PSI (20 ± 1,38 bar). 10. Record Pressure __________ TLS PRESSURE 11. Remove the Hose and Fitting from the Torque Limiter Supply Spool and Plug the Port 12. Reset Pump Margin Spool (Approximately 6 Turns Out.) II. “Pump Margin Pressure Adjustment” on page 7 13. Run Engine at High Idle 14. Adjust as Necessary to get 363 ± 20 PSI (25 ± 1,38 bar). 15.

Record Pressure __________ PM PRESSURE 16. Remove 725 PSI (50 bar) pressure gauge. III. “Back-up Relief Valve Adjustment” on page 8 17. Install 5000 PSI (345 bar) gauge ont he test port on the six spool valve. 18. Turn the load sense relief valve in 3/4 turn. 19. Run engine at high idle and curl the bucket until the bucket cylinder is fully extended and the relief valve opens. 20. Adjust back-up relief valve as necessary to get 4350 ± 50 PSI (300 ± 3,45 bar). 442 Excavator 20-50-1 Service Manual