Bobcat Company 442 — Initial Torque Limiter Valve Setting

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-77 Initial Torque Limiter Valve Setting The following procedures are only used if the adjustment assembly is removed. Figure 20-50-75 4.21” (107 mm) P-40592 1 Measure from the cap to the top of the small adjusting screw [Figure 20-50-77] . Set the small adjustment screw to 4.21 inches (107 mm). Figure 20-50-78 N-23336 Remove the dust cap (Item 1) [Figure 20-50-75] . Figure 20-50-76 2 1 3.78” (96 mm) P-35330 Align the linkage pin (Item 1) on the hydraulic piston pump into the hole (Item 1) [Figure 20-50-78] in the torque limiter valve.

P-40592 Turn the valve slightly to align the dowel pin (Item 2) on the hydraulic piston pump into the hole (Item 2) [Figure 20-50-78] in the torque limiter valve. Measure from the cap to the top of the large adjustment screw. Set the large adjustment screw to 3.78 inches (96 mm) [Figure 20-50-76] . NOTE: Care should be taken not to scratch or damage the valve spool. NOTE: Before tightening the bolts, make sure the dowel pin is aligned with the housing. 442 Excavator 20-50-29 Service Manual