Bobcat Company 442 — Disassembly

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-102 Disassembly IMPORTANT 3 When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. 1 2 I-2003-0888 N-23355 Clean the outside of the hydraulic piston pump with solvent and dry with compressed air. Remove the pin assembly (Item 1) [Figure 20-50-102] . Remove the torque limiter valve.(See “Torque Limiter Valve Removal and Installation” on page 20. NOTE:

The position of the dowel pin (Item 2) on the pin assembly, with the locating hole on the swash plate cradle (Item 3) [Figure 20-50-102]. Remove the pump control assembly. See “Pump Control Removal And Installation” on page 32. Figure 20-50-103 Remove the pump coupler. See “Coupler Removal And Installation” on page 18. Figure 20-50-101 1 1 P-35350 Remove the plug (Item 1) [Figure 20-50-103] from the pump housing and drain the oil. N-23354 Remove the screw (Item 1) [Figure 20-50-101] from the pin assembly. 442 Excavator 20-50-39 Service Manual