HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Hydraulic Pump Work Sheet (Cont’d) 58. Record Pressure __________ PM PRESSURE IV. “Load Sense Relief Valve Adjustment” on page 8 59. Install 5000 PSI (345 bar) Gauge on the test port on the six spool control valve. 60. Run Engine at High Idle and curl the bucket until the bucket cylinder is fully extended and the relief valve opens. 61. Adjust Load Sense Relief Valve as Necessary to get 4060 ± 50 PSI (280 ± 3,4 bar). 62. Record Pressure __________ PRESSURE 63. Remove the 5000 PSI (345 bar) Gauge, from the Pump Diagnostic Coupler at the Control Valve. V. “Torque Limiter Adjustment” on page 9 64.
Remove the inlet hose from the six spool hydraulic control valve, install a cap on the valve and install the inlet hose on the inlet side of the hydraulic tester. 65. Route the outlet hose of the hydraulic tester to the hydraulic reservoir. 66. Bottom out the pump margin spool (approximately six turns in) 67. Run engine at high idle. 68. Free flow on the hydraulic tester is 40 GPM (152 L/min) 69. Adjust the hydraulic tester to 1450 PSI (100 bar) 70. Adjust torque limiter to 41 GPM (155 L/min). 71. Record Flow and Engine RPM. __________ FLOW 72. Adjust the Hydraulic Tester to 3480 PSI (240 bar). 73. Adjust the Torque Limiter to obtain 19 GPM (72 L/min) 74. Record Flow and Engine RPM.
__________ FLOW 442 Excavator 20-52-2 Service Manual