HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-68 Initial Torque Limiter Valve Setting The following procedures are only used if the adjustment assembly is removed. Figure 20-52-66 4.44” (113 mm) P11473 1 Measure from the cap to the top of the small adjusting screw [Figure 20-52-68] . Set the small adjustment screw to 4.44 inches (113 mm). Figure 20-52-69 P11472 1 3 Remove the dust cap (Item 1) [Figure 20-52-66] . Figure 20-52-67 2 4 P-58601 3.98” (101 mm) Align the linkage pin (Item 1) on the hydraulic piston pump into the hole (Item 2) [Figure 20-52-69] in the torque limiter valve.
P11473 Turn the valve slightly to align the dowel pin (Item 3) on the hydraulic piston pump into the hole (Item 4) [Figure 20-52-69] in the torque limiter valve. Measure from the cap to the top of the large adjustment screw. Set the large adjustment screw to 3.98 inches (101 mm) [Figure 20-52-67] . NOTE: Care should be taken not to scratch or damage the valve spool. NOTE: Before tightening the bolts, make sure the dowel pin is aligned with the housing. 442 Excavator 20-52-26 Service Manual