Bobcat Company 442 — Assembly

HYDRAULIC GEAR PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-53-17 Assembly 2 Clean all parts in solvent and dry with compressed air. Apply clean hydraulic oil or assembly lube on the new O- rings and seals. 1 Figure 20-53-15 1 P-58501 Install the seal (Item 1) and back-up ring (Item 2) [Figure 20-53-17] on both bearings. Figure 20-53-18 P-58498 2 1 Install the seal (Item 1) [Figure 20-53-15] . Figure 20-53-16 1 P-58503 Install the bottom bearing (Item 1) [Figure 20-53-18] in the housing. NOTE: The position of the V portion (Item 2) on the bearing plate (Item 1) [Figure 20-53-18] must point towards the pressure port on the housing.

P-58497 Install the snap ring (Item 1) [Figure 20-53-16] . 442 Excavator 20-53-7 Service Manuall