TRAVEL MOTOR (CONT’D) Figure 20-70-6 Disassembly 1 2 Drain the travel motor oil. (See Draining The Travel Motor on Page 10-120-1.) Figure 20-70-4 1 1 2 P-61589 3 Remove the O-ring (Item 1) and planetary carrier (Item 2) [Figure 20-70-6] . Place the carrier in a vice equipped with padded jaws. P-61585 Figure 20-70-7 Remove the drain plugs (Item 1), snap ring (Item 2) and cover (Item 3) [Figure 20-70-4] . 1 Figure 20-70-5 1 1 1 P-61591 Remove the snap rings (Item 1) [Figure 20-70-7] . P-61588 Drill a hole in the center of the bushing (Item 1) [Figure 20-70-5] using a number 3 drill bit. Thread the hole using a 1/4 x 28 inch N.F. tap.
Install a 1/4 x 28 inch bolt in the bushing, and pull the bushing out. 442 Excavator 20-70-3 Service Manual