TRAVEL MOTOR (CONT’D) Figure 20-70-14 Disassembly (Cont’d) Figure 20-70-12 1 1 1 P-61599 1 Center punch and drill the nut where shown (Item 1) [Figure 20-70-14] . P-61597 Remove the snap rings (Item 1) [Figure 20-70-12] . Split and remove the nut. Figure 20-70-13 NOTE: The nut will be destroyed and a NEW nut must be installed. Figure 20-70-15 1 1 1 2 P-61598 Pry the planetary gears (Item 1) [Figure 20-70-13] off of the carrier. P-61600 Install a puller (Item 1) on the ring gear (Item 2) [Figure 20-70-15] . Record the orientation of the gear/bearing assembly. The gear/bearing assembly can only be installed in one direction. Remove the ring gear. 442 Excavator 20-70-5 Service Manual