Bobcat Company 442 — Assembly

SWING MOTOR (CONT’D) Figure 20-90-34 Assembly Clean all parts in solvent and dry with compressed air. Do not use cloth or paper because small pieces of material can get into the system and cause damage. Check all parts for rough surfaces and wear, replace any worn or damaged parts. 1 Install new seals, O-rings and bearings. Lubricate the parts with clean hydraulic oil during assembly. P-38706 Figure 20-90-33 Install the outer bearing race (Item 1) in the carrier (Item 2) [Figure 20-90-34] . 1 Install the outer bearing race (Item 1) in the carrier (Item 2) [Figure 20-90-34] . Figure 20-90-35 P-38702 Put the shaft assembly in a vise and install the inner bearing (Item 1) [Figure 20-90-33] .

1 2 P-38707 Install the inner bearing race (Item 1) and bearing carrier (Item 2) [Figure 20-90-35] on the shaft assembly. 442 Excavator 20-90-10 Service Manual