Bobcat Company 442 — Assembly

SWING MOTOR DRIVE CARRIER (CONT’D) Figure 20-91-43 Assembly Clean all components in solvent and dry with compressed air. Replace all seals and components that are worn or damaged. Figure 20-91-41 1 P-40014 1 Pack the lower bearing (Item 1) [Figure 20-91-43] with a good quality high temperature NLGI grease. Figure 20-91-44 P-40008 Install the washer (Item 1) [Figure 20-91-41] . Figure 20-91-42 1 P-40015 Press the bearing (Item 1) [Figure 20-91-44] on the shaft. 1 P-40009 NOTE: Make sure the tab (Item 1) [Figure 20-91-42] is installed in the slot of the shaft. 442 Excavator 20-91-13 Service Manual