Bobcat Company 442 — Disassembly And Assembly

JOYSTICK CONTROL PATTERN SELECTOR VALVE (CONT’D) Figure 20-100-6 Disassembly And Assembly Figure 20-100-4 1 1 1 2 2 2 1 P-36288 Remove the O-rings (Item 1) and back-up rings (Item 2) [Figure 20-100-6] from the spool. P-36284 Figure 20-100-7 Remove the nut (Item 1) and coil (Item 2) [Figure 20- 100-4] from the spool. 2 2 Installation: Tighten the nut to 3-5 ft.-lb. (4-7 N•m) torque. NOTE: Overtightening the coil nut may cause spool or coil failure. Figure 20-100-5 1 P-36289 Remove the fitting (Item 1) [Figure 20-100-7] . 1 NOTE: Do not remove the fittings (Item 2) [Figure 20- 100-7] The fittings are welded to the valve block. Removing the fittings will damage the fittings and valve block.

P-36286 Installation: Clean all components with solvent and dry with compressed air. Inspect all parts and replace any that are damaged. Remove the spool (Item 1) [Figure 20-100-5] . Use new O-rings and back-up rings. Apply clean hydraulic oil to the O-rings and back-up rings during assembly. 442 Excavator 20-100-3 Service Manual