Bobcat Company 442 — Removal And Installation

HYDRAULIC RESERVOIR Figure 20-130-3 Removal And Installation Remove the rear cover. (See REAR COVER on Page 40- 150-1.) Remove the right side cover. (See RIGHT SIDE COVER on Page 40-160-1.) 1 Tilt the cab. (See Tilting The Cab on Page 10-160-2.) 1 Remove the counterweight. (See COUNTERWEIGHT on Page 40-170-1.) Remove the filter mount. (See HYDRAULIC FILTER MOUNT on Page 20-120-1.) 2 P-38627 Figure 20-130-1 Remove the 2 bolts (Item 1) [Figure 20-130-3] and washers from the side of the center panel. Remove the panel (Item 2) [Figure 20-130-3] . 1 IMPORTANT When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean.

Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. P-38628 I-2003-0888 Figure 20-130-4 Figure 20-130-2 1 1 2 P-40535 P-38629 Remove the 2 bolts (Item 1) and [Figure 20-130-2] and washers from the top of the center panel. Mark and remove the 5 hoses (Item 1) and disconnect the wire harness (Item 2) [Figure 20-130-4] . 442 Excavator 20-130-1 Service Manual