Bobcat Company 442 — Removal And Installation

HYDRAULIC BREAKER APPLICATION VALVE (S/N 522311001 & ABOVE) Figure 20-160-2 Removal And Installation Tilt the cab. (See Tilting The Cab on Page 10-160-2.) Figure 20-160-1 1 2 2 P-33166 1 Remove the tee fitting (Item 1) [Figure 20-160-2] . Remove the hose (Item 2) [Figure 20-160-2] . P-33165 Figure 20-160-3 Remove the wire harness (Item 1) [Figure 20-160-1] from the solenoid. 2 NOTE: The solenoid nut (Item 2) [Figure 20-160-1] may have to be loosened and the solenoid turned to access the screw to remove the wire harness. 3 IMPORTANT 1 When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean.

Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. P-33167 Remove the bolts (Item 1) [Figure 20-160-3] and washers. I-2003-0888 Installation: Install 2 washers (Item 2) between the cab and valve. Install 1 washer (Item 3) [Figure 20-160-3] on the bolts. Tighten the bolts to 6-7 ft.-lb. (8-10 N•m) torque. 442 Evcavator 20-160-1 Service Manual