Bobcat Company 442 — Disassembly And Assembly

HYDRAULIC BREAKER APPLICATION VALVE (CONT’D) Figure 20-160-6 Disassembly And Assembly Figure 20-160-4 1 1 2 1 2 2 2 P-36282 Remove the O-rings (Item 1) and back-up rings (Item 2) [Figure 20-160-6] from the spool. P-36279 Figure 20-160-7 Remove the nut (Item 1) and coil (Item 2) [Figure 20- 160-4] from the spool. Installation: Tighten the nut to 3-5 ft.-lb. (4-7 N•m) torque. NOTE: Overtightening the coil nut may cause spool or coil failure. 1 1 Figure 20-160-5 1 P-36283 1 NOTE: Do not remove the 4 fittings (Item 1) [Figure 20-160-7] The fittings are welded to the valve block. Removing the fittings will damage the block and fittings. Installation:

Clean all components with solvent and dry with compressed air. P-36280 Check all components for burrs, scratches or other damage and replace if necessary. Remove the spool (Item 1) [Figure 20-160-5] . Use new O-rings and back-up rings. Apply clean hydraulic oil to the O-rings and back-up rings during assembly. 442 Evcavator 20-160-3 Service Manual