Bobcat Company 442 — Removal And Installation

BOOM LOAD HOLDING VALVE Figure 20-200-39 Removal And Installation Fully retract the bucket and arm cylinders. Lower the boom until the bucket is on the ground. 1 With the engine off and the key in the run position, move the joysticks to relieve hydraulic pressure. 1 IMPORTANT P-33392 When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. Remove the 4 bolts (Item 1) [Figure 20-200-39] . Installation: Tighten the bolts to 15-18 ft.-lb. (20-25 N•m) torque. I-2003-0888 Figure 20-200-38 Remove the valve.

Figure 20-200-40 3 2 2 2 1 1 P-33391 P-33393 Remove the load sense line (Item 1) Mark and remove the pilot pressure lines (Item 2) [Figure 20-200-38]. Remove the tubeline (Item 3) [Figure 20-200-38] . Remove the O-ring (Item 1) and back-up ring (Item 2) [Figure 20-200-40] from the valve. 442 Excavator 20-200-1 Service Manual