Bobcat Company 442 — Replacing Oil And Filter

ENGINE LUBRICATION SYSTEM (CONT’D) Put oil in the engine. (See FUEL, COOLANT AND LUBRICANTS on Page SPEC-70-1.) Replacing Oil And Filter (Cont’d) Install the fill cap. Figure 10-90-7 Start the engine and let it run for several minutes. S/N 522311001 & Above Stop the engine. Check for leaks at the oil filter. Check the oil level. 2 Add oil as needed if it is not at the top mark on the dipstick. 1 P-32692 Figure 10-90-8 S/N 528911001 & Above S/N 528611001 & Above 2 1 P-56411 Remove the oil filter (Item 1) [Figure 10-90-7] & [Figure 10-90-8] and clean the filter housing surface. Use a genuine Bobcat replacement oil filter. Put clean engine oil on the filter gasket.

Install the filter and hand tighten. Remove the drain hose and install the cap on the oil pan after the oil has been completely drained. Remove the fill cap (Item 2) [Figure 10-90-7] & [Figure 10-90-8] . 442 Excavator 10-90-3 Service Manual