Bobcat Company 442 — Removal And Installation

AUXILIARY HYDRAULICS SELECTOR VALVE Remove the tubelines (Item 1) and hoses (Item 2) [Figure 20-220-2] . Removal And Installation Figure 20-220-3 The procedure is the same for both right and left auxiliary hydraulic selector valves. The left side is shown. Place the bucket on the ground. WARNING 1 Hydraulic fluid escaping under pressure can have sufficient force to enter a person’s body by penetrating the skin. This can cause serious injury and possible death if proper medical treatment by a physician familiar with this injury is not received immediately. 2 P-36383 W-2145-0290 Stop the engine. Remove the 2 bolts (Item 1) [Figure 20-220-3] . Installation: Tighten the bolts to 29-37 ft.-lb.

(40-50 N•m) torque. With the engine off, and the key in the run position, move the control levers to relieve hydraulic pressure. Remove the auxiliary hydraulics selector valve (Item 2) [Figure 20-220-3] . IMPORTANT When making repairs on hydraulic system, clean the work area before disassemble and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. I-2056-0793 Mark the hoses and tubelines for correct installation. Figure 20-220-2 2 1 2 1 P-36381 442 Excavator 20-220-1 Service Manual