Bobcat Company 442 — Disassembly

TRACK IDLER (CONT’D) Figure 30-40-6 Disassembly (Cont’d) 1 Figure 30-40-4 1 P-40865 Remove the seal/O-ring assembly (Item 1) [Figure 30- 40-6] from both mounts. P-40863 Apply moderate heat to the plug (Item 1) [Figure 30-40- 4] to melt the thread adhesive and remove the plug. NOTE: The steel seals are a matched set. Always install the outer seal so it will run against the original inner seal. If replacing seals, always install a matched set. Drain the oil from the idler. Figure 30-40-5 Figure 30-40-7 2 1 2 1 P-40864 P-40868 Remove the seal/O-ring assembly (Item 1) [Figure 30- 40-7] from both sides of the idler.

Remove the roll pin (Item 1) and mount (Item 2) [Figure 30-40-5] from both sides of the idler. Remove the O-ring (Item 2) [Figure 30-40-7] from both ends of the shaft. 442 Excavator 30-40-3 Service Manual