Bobcat Company 442 — Assembly

TRACK IDLER (CONT’D) Figure 30-40-13 Assembly 1 Clean all parts in solvent and dry with compressed air. The seal assemblies are a matched set and must be replaced in pairs. Figure 30-40-11 1 P-40754 Place the seal assembly in the installation tool (Item 1) [Figure 30-40-13] . The O-ring and seal ring assembly has to be lubricated with alcohol, so the O-ring will slip past the housing retaining ring and seal uniformly in the motor housing radius. P-40867 Install the bushings (Item 1) [Figure 30-40-11] in the idler. Dip the seal assembly in a pan of alcohol.

Figure 30-40-14 Figure 30-40-12 1 1 P-40870 P-40705 Shake off the excess alcohol and install the seal assembly (Item 1) [Figure 30-40-14] in the mount. Install the O-ring (Item 1) [Figure 30-40-12] on the seal ring. Repeat this procedure all four seal assemblies. Use firm even pressure on the installation tool to pop the O-ring into the housing. The O-ring and seal ring must be clean and free of any dust, oil film or foreign matter. Remove the installation tool. NOTE: Inspect the seal ring for burrs before installing the O-ring. Install the O-ring making sure it is not twisted. To remove any twists, gently pull a section of the O-ring and let it snap back.

442 Excavator 30-40-5 Service Manual