UPPER TRACK ROLLER (CONT’D) Figure 30-50-7 Disassembly (Cont’d) Figure 30-50-5 1 1 2 P-40739 Press the shaft (Item 1) [Figure 30-50-7] out of the roller. P-40737 Figure 30-50-8 The roller is equipped with a two piece seal. Pry up on the outer seal (Item 1) until the inner seal (Item 2) [Figure 30-50-5] is separated from the outer seal. Remove both seals. Figure 30-50-6 1 P-40740 1 Press the shaft (Item 1) [Figure 30-50-8] off the shaft. P-40738 Remove the snap ring (Item 1) [Figure 30-50-6] . Remove the roller from the vise and drain the oil. Turn the roller over and remove the external snap ring seal cover, inner and outer seal and internal snap ring. 442 Excavator 30-50-3 Service Manual