Bobcat Company 442 — Assembly

LOWER TRACK ROLLER (CONT’D) Figure 30-60-12 Assembly 1 Clean all parts in solvent and dry with compressed air. The seal assemblies are a matched set and must be replaced in pairs. Install the bushings (Item 1) [Figure 30-60-10 on Page 4] Figure 30-60-11 1 P-40754 Place the seal assembly in the installation tool (Item 1) [Figure 30-60-12] . The O-ring and seal ring assembly has to be lubricated with alcohol, so the O-ring will slip past the housing retaining ring and seal uniformly in the housing radius. Dip the seal assembly in a pan of alcohol. Figure 30-60-13 P-40705 Install the O-ring (Item 1) [Figure 30-60-11] on the seal ring. Repeat this procedure all four seal assemblies.

The O-ring and seal ring must be clean and free of any dust, oil film or foreign matter. NOTE: Inspect the seal ring for burrs before installing the O-ring. Install the O-ring making sure it is not twisted. To remove any twists, gently pull a section of the O-ring and let it snap back. P-40755 Shake off the excess alcohol and install the seal assembly (Item 1) [Figure 30-60-13] in the mount. Use firm even pressure on the installation tool to pop the O-ring in to the mount. Remove the installation tool. 442 Excavator 30-60-5 Service Manual