Bobcat Company 442 — Draining The Travel Motor

TRAVEL MOTOR Draining The Travel Motor Checking Oil Level See the Service Schedule for the correct service interval. (See SERVICE SCHEDULE on Page 10-50-1). Figure 10-120-1 Figure 10-120-2 2 1 2 1 P-32898 P-32897 Put the machine on a level surface with the plugs positioned as shown (Items 1 & 2) [Figure 10-120-1] Put the machine on a level surface with the plugs positioned as shown (Items 1 & 2) [Figure 10-120-2] Remove the plug (Item 1) [Figure 10-120-1] . The oil level should be at the bottom edge of the plug hole. Remove both plugs (Items 1 & 2) [Figure 10-120-2] and drain into a container. Recycle or dispose of the oil in an environmentally safe manner.

Remove the plug (Item 2) [Figure 10-120-1] and add gear lube through the hole if the oil level is below the hole (Item 1) [Figure 10-120-1] . (See FUEL, COOLANT AND LUBRICANTS on Page SPEC-70-1.) After all the gear lube is removed, rotate the travel motor to the position shown [Figure 10-120-1] Install both plugs. Add gear lube to the plug hole (Item 2) until the oil level is at the bottom edge of the plug hole (Item 1) [Figure 10- 120-1] . Install and tighten the plugs. Repeat the procedure for the other side. Repeat the procedure for the other side. 442 Excavator 10-120-1 Service Manual