BATTERY (CONT’D) Using A Booster Battery (Jump Starting) (Cont’d) IMPORTANT Figure 50-20-11 Damage to the alternator can occur if: Engine is operated with battery cables disconnected. Battery cables are connected when using a fast charger or when welding on the loader. (Remove both cables from the battery.) Extra battery cables (booster cables) are connected wrong. 2 I-2023-1285 1 P-32708 Connect one end of the first cable to the positive (+) terminal of the booster battery. Connect the other end of the same cable to the positive (+) terminal (Item 1) [Figure 50-20-11] of the excavator battery. Connect the end of the second cable to the negative (-) terminal of the booster battery.
Connect the other end of the same cable to the excavator frame (Item 2) [Figure 50-20-11] (away from the battery). NOTE: See Cold Temperature Starting Procedure, in the correct Operation & Maintenance Manual. Start the engine. After the engine has started, remove the ground (-) cable first (Item 2) [Figure 50-20-11] . Disconnect the cable from the excavator battery (Item 1) [Figure 50-20-11] . IMPORTANT If jump starting the excavator from a second machine: When jump starting the excavator from a battery installed in a second machine is NOT running while using the glow plugs. High voltage spikes from a running machine can burn out the glow plugs.
I-2060-0195 442 Excavator 50-20-5 Service Manual