Bobcat Company 442 — Charging System Check

ALTERNATOR (CONT’D) ALTERNATOR (CONT'D) Alternator Identification Charging System Check Figure 50-30-16 IMPORTANT Damage to the alternator can occur if: Engine is operated with battery cables disconnected. Battery cables are connected when using a fast charger or when welding on the excavator. (Remove both cables from the battery.) Extra battery cables (booster cables) are connected wrong. 1 I-2023-1285 P-63399 If the charging system malfunctions check the following: The back cover has been removed to show alternator rectifier assembly [Figure 50-30-16] . Check the condition and tension of the fan/fuel pump drive belt.

(See FAN/FUEL PUMP BELT on Page 10-140- 1) If belt is worn or deteriorated replace. Figure 50-30-17 Inspect the alternator wiring harness and connectors at alternator. Harness and connectors must be clean and tight. 1 Check the electrolyte level in the battery. Add distilled water as needed. (Does not apply to maintenance free batteries.) 2 Verify the charge of the battery. Make sure battery is fully charged. Disconnect the battery cables (negative first, then positive). Inspect the cable clamps and battery posts for corrosion. Remove acid or corrosion from the battery and cables with a sodium bicarbonate and water solution.

Put grease on the cable ends and battery terminals to prevent corrosion. Reconnect the cables. P-63310 The alternator contains field diodes (Item 1) [Figure 50- 30-16] a capacitor (Item 1) and brush holder (Item 2) [Figure 50-30-17] . Make sure all wiring harness leads are connected. Turn all accessories OFF 442 Excavator 50-30-6 Service Manual