Bobcat Company 442 — Installing The Cab Tilt Hinges

CAB TILT PROCEDURE Figure 10-160-3 Installing The Cab Tilt Hinges Figure 10-160-1 2 1 1 1 P-33034 Install the bolts (Item 1) and washers (Item 2) [Figure 10- 160-3] . Do not tighten the bolts at this time. P-33032 Remove the four bolts (Item 1) [Figure 10-160-1] from the front of the excavator. Figure 10-160-4 Figure 10-160-2 2 2 2 1 1 P-33035 Install the bolts (Item 1)and washers (Item 2) [Figure 10- 160-4] . P-33033 Tighten the bolts to 29-37 ft.-lb. (40-50 N•m) torque. Install the hinge (Item 1) on the excavator frame. Install the washers (Item 2) [Figure 10-160-2] between the frame and the hinge. Tighten the front bolts (Item 1) [Figure 10-160-3] to 29- 37 ft.-lb. (40-50 N•m) torque.

Repeat the procedure for the right hinge. 442 Excavator 10-160-1 Service Manual