RADIATOR/OIL COOLER (S/N 522311001 & ABOVE) NOTE: The plug is located next to the alternator mount bracket. Removal And Installation Drain the coolant from the engine. Drain the hydraulic reservoir. (See Replacing The Hydraulic Oil on Page 10-100-2.) Figure 60-40-3 Remove the right side cover. (See RIGHT SIDE COVER on Page 40-160-1.) 1 1 Remove the air conditioning condenser. (See CONDENSER (S/N 522311001 & ABOVE) on Page 70- 150-1 or See CONDENSOR (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) on Page 70-151-1.) 1 Figure 60-40-1 2 1 1 1 P-36921 Loosen the hose clamps (Item 1) [Figure 60-40-3] and remove the hoses from the radiator/oil cooler.
1 1 Figure 60-40-4 P-38640 Remove the eleven bolts (Item 1) [Figure 60-40-1] and washers. 3 2 Remove the cover (Item 2) [Figure 60-40-1] . Figure 60-40-2 1 P-36922 Cut and remove the cable tie (Item 1) [Figure 60-40-4] from the lower radiator hose. NOTE: The lower hose will be removed with the radiator. 1 Loosen the hose clamp (Item 2) [Figure 60-40-4] and remove the hose from the engine. P-32849 Remove the bolt (Item 3) [Figure 60-40-4] and washer. Remove the plug (Item 1) [Figure 60-40-2] from the back side of the engine block. 442 Excavator 60-40-1 Service Manual