ENGINE COMPONENTS AND TESTING (S/N 522311001 & ABOVE) (CONT’D) Figure 60-50-39 Fuel Injection Pump Timing (Cont'd) Figure 60-50-37 P-63102 Select the proper shim as follows [Figure 60-50-39] : P-61938 Example: The injection cylinder 3 is to be replaced. Procedure: Read the code for injection pump length -A- [Figure 60- 50-37] . Enter in Table 1 [Figure 60-50-34 on Page 13] . Read off EP code for cylinder 3 from nameplate under column “EP”, e.g. 070. (Reading sequence: line 1=cyl 1, line 2=cyl 2, etc. Example: -53- Figure 60-50-38 Take corrected injection pump installation dimension (Ek) from Table 3 [Figure 60-50-34 on Page 13] according to EP code. e.g.
111.725 mm Take code for injection pump length (A) from new injection pump. e.g. 53. Take standard dimension of injection pump (Lo) from Table 1 [Figure 60-50-34 on Page 13] , e.g. 109 mm. Determine theoretical shim thickness (Ts): Ts = Ek-(Lo+A/100) Ts = 111.725 mm - (109 mm +53/100 mm) Ts = 2.195 mm = Ss 2.2 mm P-63098 Remove the dial indicator [Figure 60-50-38] . Select shim thickness (S) according to Table 2 [Figure 60-50-34 on Page 13] . Ts 2.195 mm = Ss 2.2 mm Repeat the procedure for each injection pump. 442 Excavator 60-50-14 Service Manual