Bobcat Company 442 — Fuel Injector, Checking

ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-51-42 Fuel Injector Removal And Installation (Cont’d) Figure 60-51-41 1 B-8971 Connect the nozzle to the test pump, in a down position [Figure 60-51-42] . P-58314 Operate the test pump until the nozzle valve opens: Remove the washer (Item 1) [Figure 60-51-41] from the injector. Injection Pressure:3045-3161 PSI. (210-218 bar) Fuel Injector, Checking IMPORTANT Do not disassemble or test the fuel injector nozzles unless you have the correct service and testing tools. WARNING Diesel fuel or hydraulic fluid under pressure can penetrate skin or eyes, causing serious injury or death.

Fluid leaks under pressure may not be visible. Use a piece of cardboard or wood to find leaks. Do not use your bare hand. Wear safety goggles. If fluid enters skin or eyes, get immediate medical attention from a physician familiar with this injury. W-2072-0496 The tools listed will be needed to do the following procedure: OEM1064 - Injection Nozzle Test OEM1065 - Accessory Set 442 Excavator 60-51-14 Service Manual