Bobcat Company 442 — Timing Belt Installation

ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-51-65 Timing Belt Installation Figure 60-51-63 1 1 P-58805 The crankshaft plug is located at the front of the engine block (Item 1) [Figure 60-51-65] on the exhaust manifold side. P9575 Remove the plug. The camshaft plug is located at the rear of the engine block (Item 1) [Figure 60-51-63] on the fuel injection pump side. Figure 60-51-66 NOTE: Remove the fuel injectors from the cylinder head. (See Fuel Injector Removal And Installation on Page 60-51-13). This will allow the crankshaft turn easier for timing belt installation. 1 2 Remove the plug.

Rotate the camshaft until the notch in the camshaft can be seen through the plug hole. Figure 60-51-64 B-14401 Rotate the crankshaft until the flat spot on the crankshaft throw (Item 1) can be seen through the plug hole. Turn the crankshaft back a small amount. Install the timing tool (Item 2) [Figure 60-51-66] and tighten. 1 P-58804 Install the timing tool MEL-1458 (Item 1) [Figure 60-51- 64] and tighten. 442 Excavator 60-51-22 Service Manual