RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-18 Disassembly (Cont'd) Mark the location of each main bearing cap so it will be installed in the original position. Figure 60-80-16 P-61861 Remove the thrust rings and upper half of the main bearings [Figure 60-80-18] . Figure 60-80-19 P-61859 Remove the main bearing caps bolts [Figure 60-80-16] . Remove the main bearing caps. Figure 60-80-17 P-61862 Install the balancing shaft drive gears [Figure 60-80-19] . (If equipped) P-61860 Remove the crankshaft [Figure 60-80-17] . Check the crankshaft specifications. See “Crankshaft, Checking” on page 56. 442 Excavator 60-80-6 Service Manual