CEAM025700 PC200LC-8 BOOK

COVER

CEAM025700 Operation & Maintenance Manual PC200LC -8 LATIN AMERICA HYDRAULIC EXCAVATOR SERIAL NUMBERS PC200LC-8 A90301 and up ENGINE SAA6D107E-1 This material is proprietary to Komatsu America Corp. and is not to be reproduced, used, or disclosed except in accordance with written authorization from Komatsu America Corp. It is our policy to improve our products whenever it is possible and practical to do so. We reserve the right to make changes or improvements at any time without incurring any obligation to install such changes on products sold previously. Due to this continuous program of research and development, revisions may be made to this publication.

It is recommended that customers contact their distributor for information on the latest revision. Copyright 2011 Komatsu Printed in U.S.A. Komatsu America Corp. September 2011

Page 1

COVER

California Proposition 65 Warning This machine may contain mercury in two areas: a.) The display monitor contains mercury if it has a mercury label attached. b.) Optional HID bulbs contain mercury (if the machine is so equipped). There is no risk of exposure unless the bulbs are broken. However, the monitor and/or lamps must be reused, recycled or properly disposed of in accordance with Local, State and Federal Laws at the end of their useful lives.

Page 2

INTRODUCTION

INTRODUCTION 0 PC200LC-8 0-1

Page 3

FORWARD

INTRODUCTION FORWARD This manual provides rules and guidelines which will help you use this machine safely and effectively. The precautions in this manual must be followed at all times when performing operation and maintenance. Most accidents are caused by the failure to follow fundamental safety rules for the operation and maintenance of machines. Accidents can be prevented by knowing beforehand conditions that may cause a hazard when performing operation and maintenance. Before beginning operation or maintenance, operators and maintenance personnel must always observe the following points. Read this manual thoroughly and understand its contents fully.

Read the safety messages and safety labels given in this manual carefully so that they are understood fully. Keep this manual at the storage location for the Operation and Maintenance Manual given below so that all personnel involved in working on the machine can consult it periodically. In case this manual is lost or damaged, immediately contact Komatsu or your Komatsu distributor to obtain a new copy. When you sell the machine, make sure that this manual is provided to the new owner together with the machine. In this manual, measurements are expressed in international standard units (SI). For the reference purpose, weight units used in the past are also displayed in ( ).

Storage location for the Operation and Maintenance Manual: Magazine box on the left side of the operator's seat. 0-2 PC200LC-8

Page 4