Limit speed HSB: Repeat rate EBC1: The halt brake and roller lock are not activated by the EBS if the preset maximum speed is exceeded. The repeat rate for EBC1 messages can be chosen here. Only the values 20ms or 100ms are supported. The value should only be changed according to the specifications of the vehicle manufacturer. Axle ratio: The ratio i of the driving axle control must be entered here as specified by the vehicle manufacturer. The value entered is ratio i x 25. Repeat rate EBC2: The repeat rate for EBC2 messages can be chosen here. The values 20 ms, 50ms or 100ms are supported. The value should only be changed according to the specifications of the vehicle manufacturer.
Response pressure VA, HA, ZA: The response pressure of the front axle, rear axle, and possibly additional axle must be entered here. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO. Parameter value x 0.05 bar = response pressure. Pole wheel teeth number SAE J1939 Front axle, rear axle, and additional axle: SAE J1939 monitoring released: The Pole wheel teeth number can be entered here for speed sensing on the corresponding axle. At the moment only the value ”100” is released. Communication on the SAE J1939 data bus is monitored if this checkbox is ticked. Parameter setting 8. EBS 32