Engine Cranking but Will Not Start / Difficult to Start (cont’d.) Related MIL Faults: ETC spring check / ETC faults / EST faults / TPS conflict APP faults / Encoder error / MAP faults Injector faults / Oil pressure faults G643(E) Service Manual 237 Chapter 7. Basic Troubleshooting PROBABLE CAUSE CORRECTIVE ACTION SECM / control system malfunction Check Coolant Temperature Sensor using the Service Tool; compare coolant temperature with ambient temperature on cold engine. If coolant temperature reading is 5° greater than or less than ambient air temperature on a cold engine, check resistance in coolant sensor circuit or sensor itself.
Compare CTS resistance value to “Diagnostic Aids” chart at end of this section. Verify that there is no code for ETC spring check fault. Check for 0% APP during cranking. Cycle key ON and OFF and listen for throttle check (movement) on key OFF. Check for oil pressure switch faults. Check for sensor “sticking” faults. Check TPS for stuck binding or a high TPS voltage with the throttle closed. Fuel system malfunction Check fuel lock off (propane) or fuel pump relay gasoline operation: actuator should turn “ON” for 2 seconds when ignition is turned “ON”. Check fuel pressure. Check for contaminated fuel. Check both gasoline injector and lock off fuses (visually inspect).
Check propane tank valve & pickup. A faulty in-tank fuel pump check valve will allow the fuel in the lines to drain back to the tank after engine is stopped. To check for this condition, perform fuel system diagnosis. Check FTV system for proper operation. Ignition system malfunction Check for proper ignition voltage output with spark tester. Check spark plugs. Remove spark plugs, check for wet plugs, cracks, wear, improper gap, burned electrodes, or heavy deposits. Repair or replace as necessary. Check for: • Moisture in distributor cap* • Bare or shorted wires • Worn distributor shaft/rotor* • Loose ignition coil ground • Pickup coil resistance and connections (*) Where present