Operation Gi & GXi Models Advance the control handle to FULL THROTTLE ( B ) to clear a flooded engine. In this throttle position, with the engine speed below 400 RPM ( D –cranking speed), the ECM shuts off the fuel injectors so no fuel is delivered. When the throttle position is moved back to neutral, the ECM returns to normal operating mode. WARNING! Be prepared to quickly move the control handle to IDLE once the engine starts. This will avoid over-speeding and possibly dam- aging the engine. CAUTION! Immediately after engine start-up, look at all instruments. If any readings are abnor- mal, stop the engine and determine the cause. 21183-1 Starting the Engine (Warm Start) 1.
Move the control handle to the NEUTRAL detent position. 7743722 - Downloaded from www.volvopenta.com 13/05/2008 20:17:06 2. Turn the ignition switch to START ( II ) and hold, for no longer than ten seconds or until engine starts. If the engine does not start, let go momentarily, then try again. 3. As soon as engine starts, release key to ON or RUN ( I ). 22787 CAUTION! Never leave the key in the ON ( I ) po- sition with the engine not running. Never turn the key to START ( II ) when the engine is running. Ei- ther situation could damage the engine. NOTE!
If the engine floods during a warm start, sim- ply follow the directions provided in the sec- tion entitled If the Engine Floods on page 36 to restart the engine. 21181 Stopping the Engine 1. Move the remote control lever to NEUTRAL. 2. Let engine return to idle. 3. Turn ignition key to OFF ( 0 ). CAUTION! Do not stop the engine at speeds above idle or “speed up” the engine while turning off the ignition. Do not stop the engine while in gear or while the boat is moving. Engine damage could result. VPA 7743722 English 10-2004 37