Maintenance Static Water Line Check the static water line if the loading or weight distribution in the rear of the boat has changed significantly from the boat manufacturers original design. This would include the addition of an auxiliary outboard on brackets, on- board generators, towers, personal water craft mounted on the rear of the boat, coolers, and bait wells, and so on. Static Water Line Test CAUTION! The static water line height must be tested before the engine is started for the first time. Checking the static water line will help prevent the ingestion of water into the engine and the resultant damage. 3.
Measure from bottom of the level to static water line ( A ) and record measurement. 4. Subtract measurement B from measurement A and record result ( C ). Measurement C should not be less than 14 in. (35.6 cm). 1. Load the boat and distribute weight as you would for normal boating conditions. A – B = C 2. Place a level on top of transom, measure from bottom of level to top of riser ( B ) and record measurement. 5. When the static water line does not meet these specifications, contact your Volvo Penta dealer for information on high rise extension kits. Make sure one is installed before the engine is started for the first time.
7743722 - Downloaded from www.volvopenta.com 13/05/2008 20:17:06 CAUTION! The addition of extra equipment such as a generator, auxiliary trolling motor, live wells, supplemental fuel or water tankage, etc. may alter the water line or balance point of your boat. This may cause water to enter the exhaust, causing serious engine damage. Before making changes that affect the boat’s water line, consult your dealer to see if modifications will be required on your engine. 22816 66 VPA 7743722 English 10-2004