DRESSTA Co. Ltd. TD-15H — 5.5.3. ELECTRIC SYSTEM

MAINTENANCE SECTION 5 Page 13 SEASONAL PREPARATION Outside source of heat Machines left outside for prolonged periods in sub-zero weather will suffer from "cold-soak." Lubricants become viscous and incapable of lubricating moving parts. Extreme wear could result to the engine, transmission and final drives unless proper precautions are taken. A source of outside heat is necessary under these conditions. There are electric as well as propane-fired engine coolant heaters available. Gas-fired forced air heaters may also be obtained to heat the transmission and final drives. When using such heaters follow manufacturer’s safety instructions. WARNING!

For your personal safety, use caution and follow the manufacturer's instructions when using engine block heaters to warm the coolant or external heaters to warm the tractor. 5.5.1. FUEL SYSTEM Refer to "FUEL SYSTEM" for the diesel fuels selection, which will give the most satisfactory performance. 5.5.2. COOLING SYSTEM Prepare the cooling system as follows: 1. Check the entire engine system for leaks. 2. Inspect the condition of all hoses and replace the hose and hose clamps as necessary. 3. Check the drive belts tension and adjust tension or replace a faulty belt. Refer to "CHECKING TENSION AND ADJUSTMENT". 4. Remove all debris from the radiator core using air or water under pressure.

Direct the flow through the core, opposite the normal direction of air flow. WARNING! For your personal protection, water pressure should not exceed 270 [kPa] and air pressure should not exceed 210 [kPa]. Use safety goggles. 5. Clean the radiator guard and the outside of the core. 6. Protect your cooling system from damage by using approved antifreeze and coolant. Refer to "CHANGING COOLANT". 7. Keep your cooling system clean and minimize corrosion by changing the coolant filter at correct intervals. Refer to "COOLING SYSTEM". 8. Check the condition of the fan blades. 5.5.3. ELECTRIC SYSTEM Clean the batteries and remove all corrosion from the battery terminals and cables.

Repair or replace all wires, which have worn, cracked or frayed insulation and broken or loose wires. Service the batteries. DRESSTA TD-15H