MAINTENANCE SECTION 5 Page 15 AIR CLEANING SYSTEM Fig. 5.2. Air Cleaner with Connections 1. Cover 2. Seal Ring 3. Wing nut 4. Primary Element 5. Cotter Pin 6. Wing nut 7. Safety Element 8. Cleaner Body 9. Clamp 10. Hose 11. Pre-Cleaner Cover 12. Pre-Cleaner Body 13. Filter Warning Light Switch 14. Clamp 15. Elbow Washing IMPORTANT: Never wash element in flammable liquids such as: fuel, oil, gas or solvent. DO NOT OIL ELEMENTS. Do not tap the element against a hard surface; this will damage the element. 1. Carefully tap the side or end of the element against the palm of your hand to remove loose dust. 2. Wash the element in clean, warm water 20 [°C] to 40 [°C].
A small amount of nonsudsing detergent added to water will remove the soot. 3. Rinse the element in clear water (if a hose is used, do not exceed 270 [kPa]). Shake the element carefully to remove excess water. NOTE: Do not use compressed air to speed the drying of an element; air pressure will rupture a wet element. 4. Lay the element on its side and allow it to air-dry before reinstalling. Overnight drying is usually sufficient. When drying an element, protect it from dirt and/or freezing. DRESSTA TD-15H