MACHINE TRANSPORT AND STORAGE SECTION 3 Page 3 3.1. MACHINE TRANSPORT 3.1.1. GENERAL IMPORTANT: When shipping this machine by high-speed means of transport secure the air intake cap and the exhaust outlet to protect the turbocharger from damage. Turn the system master switch to the OFF position. WARNING! When transporting the machine, use caution when loading and unloading it. Load and unload a machine an level area which fully supports the machine and the transport vehicle so it cannot move. Use loading ramps of adequate strength, low angle and proper height. 3.1.2. TRUCK When shipping this machine by truck learn obligatory regulations.
Contact local authorities for the proper shipping and loading regulations. When preparing to transport a machine by truck, have the truck and trailer level. 1. Use ramps or loading dock to maintain stability. 2. Drive the machine in its lower gear. 3. Use the lowest engine speed that will move the machine and not stall the engine. 4. The machine can be "inched" into place by holding the steering hand levers back and slowly moving them forward into the drive position. (Be careful and move the levers simultaneously otherwise the machine will turn). 5. Pulling the steering hand levers back will disconnect the drive. Pulled back part way they will permit the machine to roll freely. 6.
When the machine is properly located, stop the engine, place the transmission controls in Neutral (N), apply the Neutral Safety Lever, apply and lock the brakes and turn off the master switch. 7. Tie the machine down securely by ropes or wires and by wooden blocks to prevent unintentional movement. DANGER! Failure to secure a machine to the truck during transporting can result in property damage, personal injury or death. 3.1.3. RAILROAD FLAT CAR Respective railroad loading rules and specifications must be followed when shipping this machine on open top railroad cars. DRESSTA TD-15H