SECTION 4 OPERATING Page 12 CONTROLS AND ADJUSTMENT Fig. 4.5. Seat Belt To buckle, insert the tongue portion of the buckle into the locking portion. WARNING! Do not use bleach, color dye or solvents on the seat belt webbing, this may cause a severe loss of tensile strength. This could cause the webbing to break resulting in personal injury, it is recommended that the seat belt be cleaned only with warm water and a mild detergent. Keep belt flat to avoid twisting and roping when not being used. Do not place heavy or sharp object on the belts. 4.5.3. ENGINE SPEED AND SHUT DOWN LEVER Fig. 4.6. Engine Speed and Shut Down Lever A. Engine Speed and Shut Down Lever B.
Lever Forward to Decrease Speed C. Lever Back to Increase Speed D. Large Cutout for Engine Shut Down E. Cutout for Engine Start and Low Idle Speed F. Midium Idle Speed G. High Idle Speed This lever (A) is used to start the engine, control speed of the engine or to shut it off. Push this lever forward (B) to decrease engine speed. Pull the lever back (C) to increase engine speed. Position lever in this large cutout (D) to shut down the engine. TD-15H DRESSTA