SECTION 4 OPERATING Page 24 4.12. LOCKING BOTH TRACKS When both steering levers are pulled simultaneously all the way back, the braking action stops both tracks. WARNING! Never pull both steering levers all the way back to stop the machine unless the machine is moving very slowly. Use the foot brake to slow down or stop the machine. 4.13. DOWNGRADE OPERATION WARNING! When operating a machine downhill, always put the transmission in the low range position. Use the brake pedal to slow the machine. Never go downhill with the transmission control in neutral. Failure to do so could result in losing control of the machine and rollover could result.
Before going downgrade, select the range, which will provide full tractor control without overspeeding the engine. 4.14. OPERATING OVER AN OBSTRUCTION When crossing a log or ditch bank, use the decelerator pedal to slow the machine; and when possible, cross at an angle. Then gradually increase the power to the tracks as the machine moves forward, over, and down. If the load is light, it may also be necessary to use the brake pedal to avoid abrupt movements. 4.15. STOPPING THE MACHINE (Fig. 4.21) Fig. 4.21. Stopping the Machine 1. Brake and Decelerator Pedal 2. Brake Lock Lever 3. Transmission Neutral Lock Lever 4. Engine Speed and Shut-down Lever 5.
Transmission Shift Lever Activity order for stopping a machine: 1. Depress brake and decelerator pedal (1) until the machine is stopped. 2. Move engine speed and shut down control lever (4) to the low idle position. 3. Place transmission shift lever (5) in NEUTRAL. 4. Place neutral lock lever (3) in ON position. 5. Lock brake and decelerator pedal (1) with brake lock lever (2). TD-15H DRESSTA